红心火龙果发酵液喷雾干燥工艺优化及红心火龙果籽油的研究

以红心火龙果发酵液作为研究对象,通过优化喷雾干燥工艺制备粉剂,最佳工艺条件为:20%麦芽糊精,进液量:10mL/min,进口温度为120℃,出口温度为65℃;得到的粉剂为紫红色粉末,益生菌含量达到108cfu/g以上,口感酸甜。将发酵后的火龙果籽进行提取,得到的火龙果籽油含有丰富的十六酸、亚油酸和油酸。     

Effect of nickel concentration on biohydrogen production: Organic solid waste vs. glucose

In recent years, alternative renewable energy generation sources have been investigated, highlighting the dark fermentation process due to it’s potential to obtain hydrogen-rich gas, which can be used as an energy source. Different trace metals intervene in this biological process. Nickel is one of the most important because it is a component of the [Ni–Fe] hydrogenase enzyme that catalyzes the oxidation of H₂ in numerous bacteria. The aim of this study was to evaluate the effect of nickel on biohydrogen production from organic solid waste (OSW). The experimental setup was carried out in batch tests using OSW as the substrate, glucose as a reference compound and the valuation of Ni²⁺ doses on the operation in a Sequencing Batch Reactor. The results of the batch tests showed that when using glucose as a substrate, 2 mg Ni²⁺/g VS_inoculum generated the highest hydrogen production (774 ± 7.3 mL H₂/L/d) and highest yield (55.8 ± 3.4 mL H₂/g of glucose), which was 34.4% higher than the control. Testing of different concentrations of nickel using OSW as a carbon source showed that the highest production was obtained without Ni²⁺ addition since the nickel concentration in the residue was 0.17 ± 0.06 mgNi/gVS; consequently, hydrogen production was not affected by the lack of Ni. The addition of 0.5 mg Ni²⁺/g VS_inoculum decreased acetate and butyrate production and increased caproate production.     

Approbation of an innovative method of pretreatment of dark fermentation feedstocks

According to the International Energy Agency, only a small part of the full potential of biomass energy is currently used in the world. The annual amount of agricultural waste in the Russian Federation is estimated at about 152 million tons, and the energy potential of animal waste is 201 PJ/year. Anaerobic digestion is an efficient method of converting organic waste into renewable energy sources. Previously, the positive effect of pretreatment of various organic feedstocks in vortex layer apparatus (VLA) on the characteristics of anaerobic digestion and energy efficiency was shown. Currently, there is a significant interest in the world in obtaining biohydrogen from organic waste using the dark fermentation (DF) process. During pretreatment in the VLA, the iron working bodies are abraded and iron particles are introduced into the feedstock of the DF reactor. This may have a positive effect on the production rate and yield of hydrogen, which has not been previously studied. This work is aimed at evaluating the possibility of using the VLA as a method for pretreatment of a dark fermentation feedstock for the intensification of biohydrogen production. To achieve this goal, an experimental setup was constructed. It consisted of a 45 L DF reactor, a VLA and a process control system to collect data on the DF process parameters every 5 min. At a hydraulic retention time in the DF reactor of 24 h and in the VLA of 30 s, the hydrogen content in the biogas increased from 51.1% to 52.2%. At the same time, the pH increased from 3.85 to 4.8–4.9, and the hydrogen production rate increased by 16% to 1.941 L/(L day). The hydrogen yield was 80.9 ml/g VS. Thus, pretreatment of the feedstock in VLA can be an effective way to intensify the DF process; however, further study of the VLA operating modes is required in order to optimize the concentrations of iron particles introduced into the feedstock for the most efficient continuous production of dark fermentative biohydrogen.     

Influence of fermentation with different lactic acid bacteria and in vitro digestion on the change of phenolic compounds in fermented kiwifruit pulps

The present study aimed to evaluate the effect of fermentation and gastrointestinal digestion of three kinds of fermented kiwifruit pulps with different Lactobacillus (Lactobacillus plantarum, Lactobacillus acidophilus and Lactobacillus casei). The changes in bioactive substances (total phenolic acid, total flavonoid, vitamin C and the viable count), antioxidant capacity (DPPH, ABTS, hydroxyl radical and superoxide anion radical scavenging activity) and phenolic profiles (protocatechuic acid, protocatechualdehyde, chlorogenic acid, caffeic acid and p-coumaric acid) were detected. The result showed, compared to non-fermented kiwifruit pulp, fermentation with LP and LA had higher content of TPA, TF and V_C, as well as antioxidant capacity. Fermentation with LP and the content of protocatechualdehyde, p-coumaric acid and chlorogenic acid were increased. However, after digestion, LP showed more effect in maintaining the content of antioxidants, antioxidant capacity and the viable count rather than LA. During digestion, the content of protocatechualdehyde and p-coumaric acid was increased in fermented samples compared with non-fermented samples. Overall, compared with LA and LC, LP is more suitable for the fermentation of kiwifruit pulp.     

菌酶协同改善花生粕的饲用品质

花生粕是重要的蛋白饲料原料，但由于其氨基酸不平衡，特别是精氨酸与赖氨酸比例严重失衡（精氨酸与赖氨酸含量比值在3~4，理想的精氨酸与赖氨酸含量比值为1.0），限制了其在动物养殖中的应用。研究了复合酶预处理结合乳酸菌发酵花生粕对其品质的改善。结果表明：经菌酶协同处理后，花生粕粗蛋白质含量由46.4%提高至506%，大分子蛋白明显降解为小分子蛋白，酸溶蛋白质含量由2.3%提高至17.8%，多肽含量由1.6%提高至15.7%，蛋氨酸和赖氨酸含量分别提高了77.1%和42.0%，精氨酸降解率为18.7%，精氨酸与赖氨酸含量比值从3.7降低至2.1，总酸含量由06%提高到4.7%，其中乳酸含量由0.64 mg/g提高至14.63 mg/g。菌酶协同处理后的花生粕抗氧化性明显增强，其中每克菌酶协同处理后的花生粕对羟自由基的清除能力与171.6 mg VC相当，比花生粕（与47.6 mg VC相当）提高了2.6倍。     

Stable Light-Emitting Electrochemical Cells Using Hyperbranched Polymer Electrolyte

The choice of an adequate electrolyte is a fundamental aspect in polymer light-emitting electrochemical cells (PLECs) as it provides the in situ electrochemical doping and influences the performance of these devices. In this study, a hyperbranched polymer (Hybrane DEO750 8500) blended with a Li salt is used as a novel electrolyte in state-of-the-art Super Yellow (a polyphenylenevinylene) based LECs. Due to the desirable properties of the hyperbranched polymer and the homogeneous and smooth films that it forms with the emitting polymer, PLEC with excellent electroluminescent properties are obtained using a pulsed current bias scheme. The devices are very stable, with lifetimes in excess of 2000 h with initial luminance values above 450 cd m⁻², a peak efficiency of 12.6 lm W⁻¹, and sub-minute turn-on times. The stability of the devices is also studied by measuring the photoluminescence (PL) of the semiconductor during electroluminescent operation. The findings suggest that it is possible to observe the quenching of the PL in vertically stacked devices due to the advancement of the doped fronts in the film and an immediate PL recovery when the bias is removed.     

Nido-Hydroborate-Based Electrolytes for All-Solid-State Lithium Batteries

Hydroborate-based solid electrolytes have recently been successfully employed in high voltage, room temperature all-solid-state sodium batteries. The transfer to analogous lithium systems has failed up to now due to the lower conductivity of the corresponding lithium compounds and their high cost. Here LiB₁₁H₁₄ nido-hydroborate as a cost-effective building block and its high-purity synthesis is introduced. The crystal structures of anhydrous LiB₁₁H₁₄ as well as of LiB₁₁H₁₄-based mixed-anion solid electrolytes are solved and high ionic conductivities of 1.1 × 10⁻⁴ S cm⁻¹ for Li₂(B₁₁H₁₄)(CB₁₁H₁₂) and 1.1 × 10⁻³ S cm⁻¹ for Li₃(B₁₁H₁₄)(CB₉H₁₀)₂ are obtained, respectively. LiB₁₁H₁₄ exhibits an oxidative stability limit of 2.6 V versus Li⁺/Li and the proposed decomposition products are discussed based on density functional theory calculations. Strategies are discussed to improve the stability of these compounds by modifying the chemical structure of the nido-hydroborate cage. Galvanostatic cycling in symmetric cells with two lithium metal electrodes shows a small overpotential increase from 22.5 to 30 mV after 620 h (up to 0.5 mAh cm⁻²), demonstrating that the electrolyte is compatible with metallic anodes. Finally, the Li₂(B₁₁H₁₄)(CB₁₁H₁₂)  electrolyte is employed in a proof-of-concept half cell with a TiS₂ cathode with a capacity retention of 82% after 150 cycles at C/5.     

浅渍法发酵豇豆的工艺优化

以具有降解亚硝酸盐功能的植物乳杆菌（Lactobacillus plantarum）SD-7和具有优良抗氧化能力的植物乳杆菌（Lactobacillus plantarum）FM-LP-9为复合发酵剂（1∶1），采用浅渍法发酵豇豆。以硬度和感官评分为考察指标，通过单因素试验及响应面试验研究复合发酵剂接种量、发酵温度和发酵时间对浅渍法发酵豇豆品质的影响。结果表明，最佳发酵工艺条件为发酵温度25 ℃，接种量5%，发酵时间125 h，在此优化条件下，得到的浅渍法发酵豇豆硬度为47.31 N，感官评分为90.98分，香气浓郁、口感脆嫩。